ChinaMetalRollFormingMachine Introduction This kind of roof panel roll forming machine mainly produce steel roof/ wall sheet. As we know, steel roof/ wall sheet is widely used in large span factory building, warehouse, office buildings, villas, roof, cold storage, air purification room, stores, kiosks, and temporary housing. 1. Machine Specifications 1Coil TypePre-painted coil, Galvanized steel or G500 G550 2Width1220mm or as per client's request 3Thickness Range0.2-1mm 4Effective width1050mm or as per drawing 1Power RequirementVoltage(380V 50HZ), or according client require Main Motor power5.5kw as per sheet thickness Cutter power5.5kw as per sheet thickness 2Forming speed10-15m/min 3Forming stations13 rows, as per finial machine 4Main Frame300H beam 5Sidewall thickness14mm 6Forming shaft diameter70mm 0.01mm-0.03mm (Grinding) 7Chain1inch chain drive or as per design 8Type of cuttingRoll formed and length-set cutting 9Control systemPLC control 10Install dimension (depend on the final design)7.4m 1.5m 1.3m 11Total weight (Approx)3.5T 12Roller materialHigh grade 45# steel, hard chrome plated 13Feeding systemGuide type 14Cutting bladeCr12 15Frequency changerDelta Manual DecoilerUsage: It is used to support the steel coil and uncoil it in a turnable way. The steel coil is uncoiled automatically. Loading capacity: 5T Inner diameter: 450-508mm Guiding DeviceAdopt guiding bar and sliding block to control the width and position of the steel sheet. Pre-cutter used to cut sheet before roll forming, saving material. Roll Forming SystemMaterial of rollers: High grade 45# steel, roller surfaces polishing, hard plating chrome coated 0.05mm The polished surface and the heat treatment towards the molds also can keep the molding plate surface smooth and not easy to be marked when it is being stamped. The 5mm thick sleeve instead of galvanized pipe. To make the shaft and rollers more stable in order to make the profile Cutting deviceA. Adopts post cutting, the cutting blade material is Cr12 with quenched treatment, after cutting, there is no material wasted. B. Adopts welded frame for good rigidity. C. The cutting action is drove by the power from hydraulic station which guarantees the procession of the cutting and low Hydraulic SystemIt is controlled by gear wheel oil pump. After filling the hydraulic oil into the hydraulic oil tank, the pump drive the cutter machine to begin the cutting job. PLC Control SystemThe target piece`s length is adjustable and digit of it can be adjusted. Computed mode has two modes: automatic and manual one. The system is easy to operate and use PLC: Delta Run out tableTo receive the finished products. 2. Process DrawingChinaMetalRollFormingMachine website:http://www.jr-rollformingmachine.com/roll-forming-machine/metal-roll-forming-machine/
top of page
bottom of page